Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Yonkers Owner’s Guide

Ghost Controls keypad and intercom repair in Yonkers typically runs $145 – $285 installed, depending on whether we’re replacing a failed membrane keypad, a corroded intercom board, or the entire weather-battered housing unit. We stock Ghost Controls-compatible keypads and intercom modules on the truck, so most Yonkers repairs wrap up same trip, usually inside an hour. The typical call starts the same way: a homeowner punches in their code, hears a faint click that goes nowhere, and watches the gate sit still while the keypad flashes a code they’ve never seen before.

Call (585) 496-2148

Key takeaways:

• Most Ghost Controls keypad failures are weather-related, not electronic – Yonkers winters and salt air do the damage
• We write the exact price before touching a single wire
• OEM Ghost Controls parts and quality aftermarket equivalents both ship fast when we need them
• Every repair is covered by the 365-Day Done Right Promise

Which Ghost Controls Models This Applies To

Ghost Controls builds their keypads and intercoms to fit nearly every residential swing and slide gate opener they’ve made since the early 2010s. The keypad line runs across the AXDP, AXP1, and TSS1 series, and the same weatherproof keypad housing works whether you’re running a single gate off a Ghost Controls control board or a dual-gate setup in a Yonkers driveway off Central Park Avenue. The intercom modules are slightly different: the older GLD series wired intercoms used a four-wire run, while newer Ghost Controls wireless intercoms pair directly to the gate controller and skip the buried cable altogether.

Here’s the compatibility gotcha we see regularly in Yonkers: Ghost Controls keypads from before 2018 use a rectangular membrane with a small pin connector that does not plug into post-2018 control boards without a pigtail adapter. If someone swapped a board under the older gate and kept the original keypad, the keypad works until a cold snap shrinks the connector just enough to lose contact. We match the part by the label on the back of the keypad or the model sticker inside the intercom hub, and we’ll tell you before we order whether OEM or a quality aftermarket board makes more sense for your gate. For Ghost Controls, we lean OEM on the intercom boards because the aftermarket versions rarely match the pairing protocol, but the aftermarket keypads hold up exactly the same for $30 – $50 less.

Signs Your Ghost Controls Keypad & Intercom Is Failing

• Dead keys or keys that need three presses to register. The membrane under the buttons cracks after a few Yonkers winters, letting moisture reach the contact layer. One dead key becomes a dead row within weeks.
• Keypad beeps but gate doesn’t move. Usually a relay on the keypad’s output side or a weak signal to the control board, not the keypad itself. We test before replacing.
• Intercom audio is scratchy, one-way, or dead entirely. The speaker cone corrodes first, especially on gates facing the Hudson or slush-splashed curbs. Salt is not kind to thin speaker materials.
• Gate opens randomly or reverses mid-cycle. A shorted keypair wire in wet wiring will send phantom signals. This one reads like a poltergeist until we open the junction box and find the green crust.
• Codes self-erase or won’t program. Ghost Controls boards store codes in non-volatile memory, but when the backup battery on the board dies, some models drop codes after a power blip. A quick board reset and fresh battery on the truck beats replacing the whole keypad.

Replacement Cost & What’s Included

In Yonkers, a Ghost Controls keypad replacement installed runs $145 – $195 for a standard single-gate unit. An intercom module replacement lands between $225 – $285 installed, and if we’re doing both the keypad and intercom together, the combined job usually falls around $325 – $410. What drives the range is straightforward: whether we’re replacing just the keypad face and connector or pulling new wire, whether your intercom is the wired GLD style or the newer wireless version, and whether the existing housing can be salvaged or needs a full swap.

Every quote includes the part, the labor, sealing and weatherproofing the exterior connections, testing the full open-close cycle, and programming your existing codes back in. We test every button, every intercom button, every cycle, and we stay until the gate works like it did the day Ghost Controls shipped it. The price you get before we start is the price on the invoice. No add-ons, no “we found something else while we were in there” surprise unless you approve it in writing first.

We also stock parts for LiftMaster, Mighty Mule, and DoorKing systems, so if your gate turns out to be a mixed-brand setup, we’re already carrying what it needs.

DIY or Call Us?

A Ghost Controls keypad swap is not the most dangerous gate repair we do, but there is real electrical risk if you’re poking around a control board while it’s still powered. Low voltage means it won’t throw you across the driveway, but a shorted wire can fry the board you were trying to save, turning a $175 keypad job into a $400 board replacement. If you’re handy, you can safely check the obvious: look for cracked or lifted keypad buttons, confirm the breaker hasn’t tripped, and make sure no wire housing has pulled loose from the keypad body. Do not strip and splice wiring while the board is live, and do not attempt to repair an intercom speaker that’s gotten wet. Moisture plus circuit boards plus a homeowner guessing at wire pairs is how we end up replacing the entire gate operator instead of one small module.

If the keypad responds but the gate’s acting weird, that’s a diagnostic call, not a part swap. Call us at (585) 496-2148 and tell us what the gate is doing wrong. Nico Alvarez is known for diagnosing opener problems over the phone in under five minutes, which means you’ll usually know what’s wrong and roughly what it costs before we even roll a truck.

FAQs

Call Calder Gate Repair Yonkers for Ghost Controls Keypad & Intercom Repair

If your Ghost Controls keypad has gone quiet or your intercom crackles more than it talks, call (585) 496-2148. We’ll give you a straight answer on what’s failing, what it’ll cost, and when we can have it fixed. A live person answers twenty-four seven – no voicemail, no phone tag. You’ll get a written price before anything starts, a trackable arrival time, and a 365-Day Done Right Promise that says if the repair fails within a year, we’re back at no charge. Part of the Relay Home Co. family since 2009, Calder Gate Repair is the dedicated gate repair specialist for Yonkers and the surrounding area.

Written by Nico Alvarez, Owner, Calder Gate Repair Yonkers, serving Yonkers and nearby areas.